邳州市哪个理发店好:CISCO CASE

来源:百度文库 编辑:偶看新闻 时间:2024/04/30 03:41:32
【转】CISCO CASE--思科网络设备无法telnet。2010年07月09日 星期五 17:21转载自 cisco911最终编辑 cisco911TitleThe router cannot accept a Telnet sessionCore IssueCisco IOS? Software only allows a limited number of Telnet sessions. The router could already be at its capacity for Telnet sessions or could not be configured to accept any Telnet sessions.ResolutionTo resolve this issue, perform these steps:

  1. Establish a console session.

  2. Issue the show line command. This verifies whether the maximum number of VTY lines are already in use, as shown in this example:

    router#show line   Tty Typ     Tx/Rx    A Modem  Roty AccO AccI   Uses   Noise  Overruns   Int*    0 CTY              -    -      -    -    -      0       1     0/0       -    65 AUX   9600/9600  -    -      -    -    -      0       0     0/0       -*   66 VTY              -    -      -    -    -      2       0     0/0       -*   67 VTY              -    -      -    -    -      2       0     0/0       -    68 VTY              -    -      -    -    -      0       0     0/0       -    69 VTY              -    -      -    -    -      0       0     0/0       -    70 VTY              -    -      -    -    -      0       0     0/0       -

    The VTY lines with asterisks are in use. Two VTY lines are in use, and three others are available.

  3. Disconnect an existing Telnet session by issuing the clear line line-number command.

  4. If this does not help, the router may not be configured to accept Telnet sessions. Cisco routers do not accept incoming network connections to asynchronous ports (TTY lines) by default.

    You must specify an incoming transport protocol or specify the transport input all command before the line accepts incoming connections.

    If you are using your router as a terminal server to make console-port connections to routers or other devices, you will not be able to use Telnet to connect to these devices.

    For more information about the transport input all command, refer to the transport input section of translate lat.

Problem TypeConsole, aux port and Telnet connectivityWhen Problem OccursContinuouslyIntermittent